666 Open Face PART 2

We've been brainstorming a few things before we jump into the teardown, among them were*Wait for the new Carb Boots and Air filters to come in so we could start it up to make sure everything is running …*Work out whether we needed to purchase new clip-ons or use the existing hi-rise ones lower on the forks under the tripple.*Work out where we were going to install the battery.

My experience with 3D printing is quite limited, I recently printed out a camera mount which took me a week to configure only to realise I could have downloaded a drawing of the exact thing I was after. I've also …It was only a matter of time before a 3D printed motorcycle was created.